Sunwind 29, ny motor

Sunwind 29

Built in Finland in 1981, this sailboat was designed by Tord Sundén and is perfect for long vacations in the archipelago. It has two berths in the forepeak, 2 ½ sleeping places in the salon, and a quarter berth in the stern. The boat is fully equipped with mooring, anchor, fenders, kitchen equipment, etc. The interior is made of teak and is in very good condition.

Google Sunwind 29 to find the Sundwind Club where you can find all the measurements and specifications (as well as a very charming brochure). The boat was inspected without remarks in 2012 by a certified inspector.

• Length: 8.89 m
• Width: 2.90 m
• Depth: 1.60 m
• Headroom up to the forepeak about 187 cm

The boat has a new Volvo Penta D1-20F installed in 2014 by Brohäll Marin, Bullandö, a new drive in 2014, and a new propeller in 2014. It has 135 operating hours since installation and has been serviced by Brohäll Marin every year.

• Main sail about 10 years old, good condition, reviewed by Boding Segelmakare -18
• Roller furling jib (self-tacking), good condition, reviewed and re-sewn to roller system by Boding -18
• Selden roller furling jib installed -18
• Genoa that works but not sewn to roller system
• Spinnaker in new condition
• Sea water filter -18
• Garmin GPS/Plotter with card for the east coast -15
• Echo sounder -16
• Handheld VHF -16
• 3-burner gas stove with oven
• LED lighting in forepeak and salon -17
• Large Delta anchor in the stern and smaller Bruce anchor in the bow, both with anchor line
• Thermo 2500 heater, serviced -15, outlet in salon and forepeak
• Shore power (no battery charging) -16
• Porta Potti with deck discharge -17
• Aft swim platform with ladder -16 and -23
• Bow pulpit with ladder -16
• 2 batteries, one for consumption and one for starting -23
• 50W solar panel -16
• Newly washed, impregnated, and renovated sprayhood and boom cover -20
• Parts of the deck painted with Kiwigripp -23
• 4 Tyresö supports 2 Biltema supports -22

The boat is located in Kvarnviken, Bromma.