I understand that I do not have time to complete the boat and unfortunately have to part with it. Will I lose money on this? Absolutely.Why such a low price? Well, because there are some things that need to be done before it goes in the water. Some things need to be done before launching, see below. The rest is for comfort and to make it nice. This work takes some time, which I unfortunately do not have.What has been done?All deck equipment has been dismantled except for the pulpit in the bow. All old screw holes have been removed and filled, as well as broken plastic parts. The deck and non-slip surface are worn, so I have started sanding it down to apply new coating.The boat is located in Gustavsberg and the mast is in a mast shed in Södertälje. The buyer is responsible for and arranges the transport of the boat and mast.New equipment (value approximately 59,000 SEK)2 new Lewmar EVO 30 self-tailing winches (value 21,980 SEK)2 new triple blocks from Rutgerson RC75X (value 4,380 SEK)2 new deck hatches Vetus Magnus 501x501 (value 15,790 SEK)4 new turnbuckles for tie-rods Bronze from Benns (value 3,000 SEK)2 new Barton track and genoa cars (value 4,280 SEK)2 new Spinlock snatch blocks (value 1,790 SEK)New cable passage Cableport (value 999 SEK)New halyard and new ropes in dyneema and polyester (value approximately 2,000 SEK)2 new ejector air vents (value 930 SEK)Equipment (older)Rig: Masthead, black Briand mastEngine: Volvo Penta MD2B. Freshwater cooled until 2020, seawater cooled in 2021 and has not been used since due to boat renovation. Worked fine two years ago when it was in the water but is now locked due to being unused. Probably just needs a small check-up. Replaced cylinder head gasket and various other gaskets in 2020.Roller furling system PlastimoSail wardrobe with 1 mainsail, 1 genoa, and 1 storm jib. All older but intact and crispy.ENO gas stove and two gas bottles.Lots of fenders and ropes.Cushions for the salon, berths, and cockpit. Older but both cushions and fabric have been washed.2 used Lewmar 30 winches and some used winchesAnchor with chain and anchor lineFoldable bathing ladderBow ladderAluminum cover frameGarmin GPSmap 182C with nautical charts (older)Waeco refrigerator2 AGM consumption batteries and 1 lead-acid battery for startingFiberglass doghouse (dismantled and needs new windows)Exterior teak deck (needs sanding)What needs to be done to make it seaworthy?Fill in the profiles after repairing along the railing so that the correct profile is obtained for the lifeline attachments (easy job)Check the engineDeck equipment needs to be reinstalled, winches, track cars, snatch blocks, lifeline attachments, and pushpit.Either reinstall the deck hatch (screw and sealant) or install the new ones that come with itNew through-hulls need to be installed for the galley, toilet sink, and where the old log was locatedThe mast support and mast step need to be reinstalled (easy job)Tie-rods need to be installed (easy job)Bilge pump needs to be replaced (existing one is broken)Optionally, sand and paint the deck.
Värmdö.
Get contact data at 
